READ DATA LIST
Tech Tips
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the power switch OFF.
Connect the intelligent tester to the DLC3.
Turn the power switch ON (IG).
Turn ON the tester.
Enter the following menus: Chassis / Air suspension / Data List.
According to the display on tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| (Up&Down)G Sensor FR | G (up & down) suspension control ECU (houses acceleration sensor) reading / min.: -1045.29 m/s2 max.: 1045.26 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle (FR) is bounced |
| (Up&Down)G Sensor FL | G (up & down) acceleration sensor (for Front) reading / min.: -1045.29 m/s2 max.: 1045.26 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle (FL) is bounced |
| (Up&Down)G Sensor Rear | G (up & down) acceleration sensor (for Rear) reading / min.: -1045.29 m/s2 max.: 1045.26 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle (rear) is bounced |
| (Back&Forth)G Sensor | G sensor reading / min.: -4.5952 m/s2 max.: 4.5593 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle is bounced |
| FR Height Control Sensor | Front height control sensor RH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| FL Height Control Sensor | Front height control sensor LH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RR Height Control Sensor | Rear height control sensor RH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RL Height Control Sensor | Rear height control sensor LH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| Height Offset Max | Display of amount of vehicle height calibration that is possible / min.: 0.0 mm (0 in.) max.: 6553.5 mm (258 in.) |
min.: 0 mm (0 in.) max.: 20 mm (0.787 in.) |
- |
| FR Height Adjust | Display of vehicle height offset recorded value of front right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| FL Height Adjust | Display of vehicle height offset recorded value of front left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RR Height Adjust | Display of vehicle height offset recorded value of rear right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RL Height Adjust | Display of vehicle height offset recorded value of rear left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| FR After Height Adjust | Display of after-calibration vehicle height value of front right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/-20 mm (0.787 +/-0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/-20 mm (1.181 +/-0.787 in.) |
|||
| FL After Height Adjust | Display of after-calibration vehicle height value of front left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/-20 mm (0.787 +/-0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/-20 mm (1.181 +/-0.787 in.) |
|||
| RR After Height Adjust | Display of after-calibration vehicle height value of rear right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/-20 mm (0.787 +/-0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/-20 mm (1.181 +/-0.787 in.) |
|||
| RL After Height Adjust | Display of after-calibration vehicle height value of rear left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/-20 mm (0.787 +/-0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/-0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/-20 mm (1.181 +/-0.787 in.) |
|||
| Stop Light Switch | Stop light switch / ON or OFF |
ON: Brake pedal is depressed OFF: Brake pedal is released |
- |
| COMFORT Switch | Drive mode select switch "COMFORT" mode / ON or OFF |
ON: COMF mode OFF: Not in COMF mode |
- |
| SPORT Switch | Drive mode select switch "SPORT S+" mode / ON or OFF |
ON: SPORT S+ mode OFF: Not in SPORT S+ mode |
- |
| Door Switch | Door switch / ON or OFF |
ON: Door is open OFF: All doors are closed |
- |
| Damping Force Switch 1 | Height control switch / ON or OFF |
ON: Switch is pressed and held OFF: Switch is not pressed |
- |
| Height Position | Height position / Normal or Not Normal |
Normal: Height position is NORMAL Not normal: Height position is not NORMAL |
- |
| Height Control | Vehicle height control condition reading / ON or OFF |
ON: Vehicle height control is operating OFF: Vehicle height control is not operating |
- |
| Height Offset | Vehicle height offset calibration condition reading / ON or OFF |
ON: Vehicle height offset calibration complete OFF: Before vehicle height offset calibration |
- |
| HV Ready | Power switch / ON or OFF |
ON: Power switch is ON (READY) OFF: Power switch is OFF |
- |
| TD Terminal | TD terminal / ON or OFF |
ON: Height control is not operating OFF: Height control is operating |
- |
| TC Terminal | TC terminal / ON or OFF |
ON: DTC is output OFF: DTC is not output |
- |
| TS Terminal | TS terminal / ON or OFF |
ON: During test mode OFF: Normal mode |
- |
| IG Power Source Voltage | ECU power supply voltage / min.: 0.0 V max.: 25.5 V |
Power switch is ON (IG): 11 to 14 V | - |
| Steering Angle | Steering angle sensor reading / min.: -49152.0 deg max. 49150.5 deg |
Actual steering angle Left turn: reading increases Right turn: reading decreases |
- |
| Engine Speed | Cam position sensor reading / min.: 0 rpm max.: 25500 rpm |
Actual engine speed | Speed indicated on the combination meter |
| FR Wheel Speed | Front right wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| FL Wheel Speed | Front left wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| RR Wheel Speed | Rear right wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| RL Wheel Speed | Rear left wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| Damper Step FR | Damper step (Front RH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Damper Step FL | Damper step (Front LH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Damper Step RR | Damper step (Rear RH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Damper Step RL | Damper step (Rear LH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Max Damper Step FR | Damper step (Front RH) / min.: 0 step max.: 255 step |
17 step | - |
| Max Damper Step FL | Damper step (Front LH) / min.: 0 step max.: 255 step |
17 step | - |
| Max Damper Step RR | Damper step (Rear RH) / min.: 0 step max.: 255 step |
17 step | - |
| Max Damper Step RL | Damper step (Rear LH) / min.: 0 step max.: 255 step |
17 step | - |
| Compatible Constant Information | Information used to change the compatible constant min.: 0 max.: 255 |
- | - |
| Identical Constant Information | Information used to change the identical constant min.: 0 max.: 255 |
- | - |
| Design Constant Information | Information used to change the design constant min.: 0 max.: 255 |
- | - |
| Number of Trouble Codes | Number of DTC recorded/ min.: 0 max.: 255 |
0 | - |
Enter the following menus: Body Electrical / Center Console Switch / Data List.
According to the display on tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| HEIGHT HIGH Switch | Height control switch / ON or OFF |
ON: Switch is pressed and held OFF: Switch is not pressed |
- |
| SPORT Mode Switch | Drive mode select switch "SPORT S+" mode / ON or OFF |
ON: Switch turned right and held OFF: Switch is not turned |
- |
| COMFORT Mode Switch | Drive mode select switch "COMFORT" mode / ON or OFF |
ON: Switch turned left and held OFF: Switch is not turned |
- |
PERFORM ACTIVE TEST
Tech Tips
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Turn the power switch OFF.
Connect the intelligent tester to the DLC3.
Turn the power switch ON (IG).
Turn ON the tester.
Enter the following menus: Chassis / Air suspension / Active Test.
According to the display on tester, perform the "Active Test".
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Damper Step FR | Changes front damper RH step | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| Damper Step FL | Changes front damper LH step | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| Damper Step RR | Changes rear damper RH step | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| Damper Step RL | Changes rear damper LH step | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| FR Wheel Up/Down | Right front vehicle height | UP or DOWN | - |
| FL Wheel Up/Down | Left front vehicle height | UP or DOWN | - |
| RR Wheel Up/Down | Right rear vehicle height | UP or DOWN | - |
| RL Wheel Up/Down | Left rear vehicle height | UP or DOWN | - |
| Front Right Solenoid | Front height control solenoid valve RH | ON or OFF | Operation of solenoid (clicking sound) can be heard |
| Front Left Solenoid | Front height control solenoid valve LH | ON or OFF | Operation of solenoid (clicking sound) can be heard |
| Rear Right Solenoid | Rear height control solenoid valve RH | ON or OFF | Operation of solenoid (clicking sound) can be heard |
| Rear Left Solenoid | Rear height control solenoid valve LH | ON or OFF | Operation of solenoid (clicking sound) can be heard |
| Motor Relay | Suspension control relay | ON or OFF | Operation of solenoid (clicking sound) can be heard |
| Exhaust Solenoid | Exhaust solenoid | ON or OFF | Operation of solenoid (clicking sound) can be heard |