TIRE PRESSURE WARNING RECEIVER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RHD and LHD models.

  • The procedure listed below is for the LHD model.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE TELEMATICS TRANSCEIVER

    Click here

  8. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER


    1. A000YS9

      Disconnect the connector.

    2. Remove the bolt and tire pressure warning ECU and receiver.