TIRE PRESSURE WARNING INITIATOR DRIVER(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  8. REMOVE TIRE PRESSURE MONITOR INITIATOR DRIVER


    1. A000X88

      Disconnect the connectors.

    2. Remove the bolt, nut and tire pressure monitor initiator driver with bracket.

    3. A000YNV

      Remove the 2 nuts and tire pressure monitor initiator driver.