TIRE PRESSURE WARNING INITIATOR DRIVER(for LHD) INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE MONITOR INITIATOR DRIVER

   
   

   1. Install the tire pressure monitor initiator driver with the nut.

      Torque:

      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

   2. Install the tire pressure monitor initiator driver with the bolt and nut.

   3. Connect the connectors.

2. INSTALL PASSENGER SIDE JUNCTION BLOCK

   
   

   1. Install the passenger side junction block with the bolt and nut.

      Torque:

      for Nut

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      for Bolt

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

   2. Connect the connectors.

3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

   Click here

4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. INSTALL BATTERY SERVICE HOLE COVER LH

   Click here

6. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

   Click here

7. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

   Click here

8. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

   Click here

9. INSPECT TIRE PRESSURE WARNING SYSTEM

   Click here