STEERING KNUCKLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. REMOVE FRONT AXLE SHAFT NUT LH

    Click here

  3. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  4. REMOVE FRONT DISC

    Click here

  5. REMOVE FRONT DISC BRAKE DUST COVER LH

    Click here

  6. DISCONNECT SKID CONTROL SENSOR WIRE

    Click here

  7. REMOVE FRONT SPEED SENSOR LH

    Click here

  8. DISCONNECT TIE ROD ASSEMBLY LH

    Click here

  9. DISCONNECT FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH

    Click here

  10. DISCONNECT FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH

    Click here

  11. REMOVE STEERING KNUCKLE SUB-ASSEMBLY LH


    1. A000TXE

      Remove the 3 bolts. Then disconnect the steering knuckle from the front lower ball joint.

    2. A000TTW

      Using a plastic-faced hammer, lightly tap the end of the front drive shaft to remove the front axle hub and steering knuckle from the front drive shaft.

      Tech Tips

      If the spline connection is tight, using a brass bar and hammer, tap the front drive shaft.

  12. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


    1. A000WAL

      Remove the 4 bolts and front axle hub from the steering knuckle.