PROPELLER SHAFT ASSEMBLY DISASSEMBLY

PROCEDURE


  1. REMOVE PROPELLER INTERMEDIATE SHAFT


    1. A000TYRE11
      Text in Illustration
      *a Matchmark

      Put matchmarks on the intermediate shaft and propeller shaft.

    2. Disconnect the intermediate shaft and propeller shaft.

      Note

      Be careful not to damage the spline.

    3. Remove the adjusting nut from the intermediate shaft.

    4. A000YMPE12
      Text in Illustration
      *1 Protective Tape

      Remove the dust boot from the propeller shaft.

      Tech Tips

      If the dust boot is to be reused, remove it after wrapping protective tape around the spline, so it will not be damaged.

  2. REMOVE NO. 1 CENTER SUPPORT BEARING ASSEMBLY


    1. A000U3T

      Using a snap ring expander, remove the snap ring.

    2. A000VSUE07
      Text in Illustration
      *1 Center Support Bearing
      *2 No. 2 Dust Deflector

      Using SST and a press, press out the center support bearing and No. 2 dust deflector.

      SST
      09950-00020
    3. A000TDSE07

      Using SST and a press, press out the No. 1 dust deflector.

      SST
      09950-00020