TRANSFER OIL REPLACEMENT

PROCEDURE

1. DRAIN TRANSFER OIL

   
   
   1. 

      Text in Illustration

      *1	Filler plug
      *2	Drain plug

      Using a 10 mm hexagon wrench, remove the filler plug and gasket.

   2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the transfer oil.

2. ADD TRANSFER OIL

   
   

   1. Install a new gasket into the drain plug and then install the drain plug with a 10 mm hexagon wrench.

      Torque:

      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

   2. 

      Text in Illustration

      *a	0 to 5 mm (0 to 0.196 in.)

      Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

      Oil grade
      Toyota Genuine Transfer gear oil LL 80 or equivalent
      Standard capacity
      0.7 liters (0.7 US qts, 0.6 Imp. qts)

      Note

      
      

      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

      • Keep the vehicle level during inspection.

   3. Install a new gasket into the filler plug and then install the plug with a 10 mm hexagon wrench.

      Torque:

      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

   4. Drive the vehicle and check the oil level again.