FRONT DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL REPLACEMENT

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. DRAIN FRONT DIFFERENTIAL OIL

    Click here

  3. REMOVE ENGINE ASSEMBLY


    1. Remove the engine assembly Click here.

  4. INSTALL ENGINE ON TO ENGINE STAND

    Click here

  5. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY

    Click here

  6. REPLACE FRONT DIFFERENTIAL CASE OIL SEAL


    1. A000WFI

      Set the front differential carrier assembly to an overhaul stand as shown in the illustration.

    2. for LH:


      1. A000UV8E02

        Using SST, remove the front differential case oil seal LH.

        SST
        09308-00010
      2. A000V5RE03

        Using SST and a hammer, tap in a new front differential case oil seal LH to the front differential carrier assembly.

        SST
        09608-32010
        09950-70010   ( 09951-07100 )
        Standard depth
        -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

        Note


        • Tap the front differential case oil seal LH uniformly so that the oil seal is straight.

        • Do not excessively tap the oil seal.

        • Make sure the difference between the maximum and minimum measured values is less than 0.57 mm (0.0224 in.), as a greater difference may lead to oil leaks.

    3. for RH:


      1. A000UU4E02

        Using SST, remove the front differential case oil seal RH.

        SST
        09308-00010
      2. A000UG1E03
        Text in Illustration
        *1 Front Differential Case Oil Seal RH

        Using SST and a hammer, tap in a new front differential case oil seal RH to the front differential carrier assembly.

        SST
        09550-60010   ( 09951-00570 )
        09950-70010   ( 09951-07100 )
        Standard depth
        1.0 to 2.0 mm (0.0394 to 0.0787 in.)

        Note


        • Tap the front differential case oil seal RH uniformly so that the front differential case oil seal RH is straight.

        • Do not excessively tap the oil seal.

        • Make sure the difference between the maximum and minimum measured values is less than 0.47 mm (0.0185 in.), as a greater difference may lead to oil leaks.

    4. A000WFI

      Remove the front differential carrier assembly from the overhaul stand.

  7. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY

    Click here

  8. INSTALL ENGINE TO VEHICLE


    1. Remove the engine from the engine stand and then install it to the vehicle Click here.

  9. ADD FRONT DIFFERENTIAL OIL

    Click here