WATER PUMP WITH MOTOR INSTALLATION

PROCEDURE

1. INSTALL WATER PUMP WITH MOTOR AND BRACKET ASSEMBLY

   
   

   1. 

      Install the water pump with motor and bracket assembly with the 2 bolts.

      Torque:

      22 N*m  { 224 kgf*cm, 16 ft.*lbf }

   2. 

      Connect the 2 water pump hoses with the 2 clips.

      Note

      Do not remove the pieces of cloth or plastic bags from the pipe and disconnected hose until installation.

   3. Connect the water pump connector.

      Note

      Do not hold the water pump with motor assembly by the connector terminals when removing or installing it.

2. ADD COOLANT (for Inverter)

   Click here

3. INSPECT FOR COOLANT LEAK

   Click here

4. INSTALL FRONT CENTER FLOOR COVER

   Click here

5. INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR

   Click here

6. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

7. INSTALL ENGINE ROOM SIDE COVER LH

   Click here

8. INSTALL ENGINE ROOM SIDE COVER RH

   Click here