OBJECT RECOGNITION ECU INSTALLATION

CAUTION / NOTICE / HINT

Note

When replacing the object recognition ECU, make sure to perform the replacement after confirming that the headlight assembly is securely installed.

PROCEDURE


  1. INSTALL OBJECT RECOGNITION ECU

    A000ZBC

    1. Attach the 2 clips to install the object recognition ECU.

    2. Install the 2 bolts.

      Torque:
      7.4 N*m  { 75 kgf*cm, 65 in.*lbf }

    3. Connect the 2 connectors.

      Note

      Do not use an object recognition ECU which has been dropped or subjected to any strong shocks.

  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

    Click here

  3. INSTALL REAR FLOOR FINISH PLATE

    Click here

  4. INSTALL TOOL BOX (w/o Spare Tire)

    Click here

  5. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

  6. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  7. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)

    Click here

  8. INSTALL ROPE HOOK

    Click here

  9. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  10. INSTALL DECK TRIM SIDE BOARD RH

    Click here

  11. INSTALL ROPE HOOK ASSEMBLY

    Click here

  12. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  13. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  14. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  15. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  16. ADJUST OBJECT RECOGNITION CAMERA

    Click here