DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A41

DTC Code DTC Name
C1A41 Brake Request Value Mismatch between ENG / EHV and Driving Support ECU

DESCRIPTION

The skid control ECU receives brake control request signals from the hybrid vehicle control ECU and driving support ECU.

When the request signals received from the hybrid vehicle control ECU and driving support ECU are not consistent, the skid control ECU determines that a malfunction has occurred and sends a malfunction signal to the driving support ECU.

If the driving support ECU receives a malfunction signal, DTC C1A41 is output. Although the skid control ECU sends a malfunction signal to the driving support ECU, the ABS does not output a relevant malfunction detection DTC.

DTC Code DTC Detection Condition Trouble Area
C1A41 While power switch is ON (IG), brake request signal from hybrid vehicle control ECU and driving support ECU is inconsistent for 1 sec.

  • Electronically controlled brake system

  • Hybrid control system

  • Hybrid vehicle control ECU

  • Skid control ECU

  • Driving support ECU

PROCEDURE


  1. CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)


    1. Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TAC / DTC.

    2. Check for DTCs.

      OK
      Electronically controlled brake system DTC is not output.

    NG

    GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Click here

    OK

  2. CHECK FOR DTC (HYBRID CONTROL SYSTEM)


    1. Using the intelligent tester, enter the following menus: Powertrain / HV / DTC.

      Check for DTCs.

      OK
      Hybrid control system DTC is not output

    NG

    GO TO HYBRID CONTROL SYSTEM Click here

    OK

  3. REPLACE HYBRID VEHICLE CONTROL ECU


    1. Replace the hybrid vehicle control ECU Click here.


    NEXT

  4. CHECK FOR DTC


    1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / DTC.

    2. Select "Clear" and clear the data.

    3. Recheck for DTC.

      OK
      DTC C1A41 is not output.

    OK

    END

    NG

  5. REPLACE SKID CONTROL ECU


    1. Replace the skid control ECU.



    NEXT

  6. CHECK FOR DTC


    1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / DTC.

    2. Select "Clear" and clear the data.

    3. Recheck for DTC.

      OK
      DTC C1A41 is not output.

    OK

    END

    NG

    REPLACE DRIVING SUPPORT ECU Click here