OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A000V7UE01
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    2. A000YQ9

      Using a 24 mm deep socket wrench, install the switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour after installation.

    3. Connect the switch connector.

  2. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the area that was worked on.

  3. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  5. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

    Click here