FUEL PUMP REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:


    • Do not smoke or be near an open flame when working on the fuel system.

    • Keep gasoline away from rubber or leather parts.

    • Do not allow fuel to spray when removing the pipe between the high pressure side fuel pump and the fuel injector. The fuel in the pipe is highly pressurized.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. REMOVE REAR NO. 2 SEAT ADJUSTER ASSEMBLY


  4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

    Click here

  5. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  6. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  7. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  8. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  9. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. REMOVE SERVICE PLUG GRIP

    Click here

  11. REMOVE REAR FLOOR NO. 2 SERVICE HOLE COVER

    Click here

  12. REMOVE FUEL TANK VENT TUBE SET PLATE

    Click here

  13. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

    Click here