CAMSHAFT(for Bank 2) INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT BEARING CAP RH


    1. Apply a light coat of engine oil to the camshaft journals, camshaft housings and bearing caps.

    2. Install the No. 1 and No. 2 camshafts to the camshaft housing.

    3. A000Y5Y

      Confirm the marks and numbers on the camshaft bearing caps and place them each in their proper positions and directions.

    4. A000VQ4E03

      Temporarily install the 8 bolts in the order shown in the illustration.

  2. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY RH


    1. A000X00E04
      Text in Illustration
      *1 No. 1 Valve Rocker Arm Sub-assembly
      *2 Valve Stem Cap
      *3 Valve Lash Adjuster Assembly
      *a INCORRECT
      *b CORRECT

      Make sure that the valve rocker arms are installed as shown in the illustration.

    2. A000TIUE02
      *1 3.5 to 4.0 mm

      Apply seal packing in a continuous line as shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
      Standard seal diameter
      3.5 to 4.5 mm (0.138 to 0.177 in.)

      Note


      • Remove any oil from the contact surface.

      • Install the camshaft housing within 3 minutes and tighten the bolts within 10 minutes after applying seal packing.

    3. A000ZNJE03

      Install the camshaft housing, and install the 18 bolts in the order shown in the illustration.

      Torque:
      for bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      except bolt A
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note


      • Do not start the engine for at least 2 hours after the installation.

      • Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing.

    4. A000XOGE06

      Tighten the 8 bolts in the order shown in the illustration.

      Torque:
      16 N*m  { 163 kgf*cm, 12 ft.*lbf }

      Note

      Thoroughly wipe clean any seal packing.

  3. SET NO. 1 CYLINDER TO TDC / COMPRESSION

    Click here

  4. INSTALL NO. 2 CHAIN TENSIONER ASSEMBLY

    Click here

  5. INSTALL NO. 1 CHAIN SUB-ASSEMBLY RH

    Click here

  6. INSTALL NO. 1 CHAIN VIBRATION DAMPER RH

    Click here

  7. INSTALL NO. 1 CHAIN TENSIONER SLIPPER RH

    Click here

  8. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY RH

    Click here

  9. INSTALL NO. 1 CHAIN SUB-ASSEMBLY LH

    Click here

  10. INSTALL NO. 1 CHAIN TENSIONER SLIPPER LH

    Click here

  11. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY LH

    Click here

  12. INSTALL NO. 1 CHAIN VIBRATION DAMPER LH

    Click here

  13. TIGHTEN CAMSHAFT TIMING GEAR ASSEMBLY

    Click here

  14. CHECK NO. 1 CYLINDER TO TDC / COMPRESSION

    Click here

  15. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY

    Click here