CAMSHAFT(for Bank 1) REMOVAL

PROCEDURE


  1. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

    Click here

  2. SET NO. 1 CYLINDER TO TDC / COMPRESSION

    Click here

  3. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY LH

    Click here

  4. REMOVE NO. 1 CHAIN TENSIONER SLIPPER LH

  5. REMOVE NO. 1 CHAIN VIBRATION DAMPER LH

    Click here

  6. REMOVE NO. 1 CHAIN SUB-ASSEMBLY LH

    Click here

  7. REMOVE NO. 3 CHAIN TENSIONER ASSEMBLY

    Click here

  8. REMOVE CAMSHAFT BEARING CAP LH


    1. A000XQ1E04
      *a Knock Pin

      Make sure that the knock pin of the camshaft is positioned as shown in the illustration.

    2. A000UMNE05

      Uniformly loosen and remove the 8 bearing cap bolts in the sequence shown in the illustration.

    3. A00101UE03

      Uniformly loosen and remove the 18 bearing cap bolts in the sequence shown in the illustration.

      Note

      Uniformly loosen the bolts while keeping the camshaft level.

    4. Remove the 7 bearing caps.

      Tech Tips

      Arrange the removed parts in the correct order.

    5. Remove the No. 3 and No. 4 camshafts.

  9. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY LH


    1. A000VTO

      Remove the camshaft housing by prying between the cylinder head and camshaft housing with a screwdriver.

      Note

      Be careful not to damage the contact surfaces of the cylinder head and camshaft housing.

      Tech Tips

      Tape the screwdriver tip before use.