DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL V-RIBBED BELT


    1. A000XTFE04
      *1 Water Pump
      *2 Crankshaft
      *3 Tensioner

      Install the V-ribbed belt as shown in the illustration.

      Note

      Check that the V-ribbed belt is properly set to each pulley.


      1. Rotate the tensioner pulley counterclockwise, and then remove the bar.

    2. A000U6CE01
      *1 CORRECT
      *2 INCORRECT

      After installing the belt, check that it fits properly in the ribbed grooves.

    3. Check by hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley.

    4. A000V4OE01

      Check that the alignment mark on the belt tensioner is within area "A".

      If it is outside area "A", replace the V-ribbed belt.

      Tech Tips

      When a new belt is installed, the alignment mark should be within area "B". If not, the V-ribbed belt is not installed correctly.

  2. INSTALL INTAKE AIR CONNECTOR PIPE

    Click here

  3. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  4. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY

    Click here

  5. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here