SFI SYSTEM, Diagnostic DTC:P1023, P2614

DTC Code DTC Name
P1023 Camshaft Position Signal Output "B" Circuit
P2614 Camshaft Position Signal Output Circuit / Open

DESCRIPTION

Refer to DTC P0010 Click here.

DTC No. DTC Detection Condition Trouble Area
P1023

Malfunction in rotation sensor of camshaft timing control motor is detected for 3 seconds

(1 trip detection logic)

 Camshaft timing control motor (for Bank 2)
P2614

Malfunction in rotation sensor of camshaft timing control motor is detected for 3 seconds

(1 trip detection logic)

 Camshaft timing control motor (for Bank 1)

MONITOR DESCRIPTION

This DTC is output when a malfunction in the intake side camshaft timing control motor's rotation sensor is detected. The camshaft timing control motor is equipped with a self diagnostic function, which is used to send diagnostic signals (VTM) to the ECM. If the ECM receives a rotation sensor malfunction signal, a DTC is output immediately (1 trip detection logic). If the engine is idled for 10 seconds, a DTC is detected.

CAUTION / NOTICE / HINT

Tech Tips


  • Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

  • When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

PROCEDURE


  1. REPLACE CAMSHAFT TIMING CONTROL MOTOR (for Bank 1 or Bank 2)


    1. Replace the camshaft timing control motor Click here.


    NEXT

  2. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the intelligent tester to the DLC3.

    2. Put the engine in inspection mode Click here.

    3. Idle the engine for 10 seconds.

    4. Enter the following menus: Powertrain / Engine and ECT / DTC.

    5. Read the DTCs.

      Result
      Display (DTC Output) Proceed to
      No output A
      Other DTCs B

    A

    END

    B

    GO TO DTC CHART Click here