BODY GENERAL MAINTENANCE

PROCEDURE

1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY

   
   

   1. Tighten the bolts and nuts on the chassis parts listed below, if necessary.

      
      

      • Front axle and suspension

      • Drivetrain

      • Rear axle and suspension

      • Brake system

      • Engine mounting

      • Other chassis parts

   2. Tighten the bolts and nuts on the body parts listed below, if necessary.

      
      

      • Seat belt system

      • Seats

      • Doors and hood

      • Body mountings

      • Fuel tank

      • Exhaust pipe system

      • Other body parts

2. INSPECT TIRE AND INFLATION PRESSURE

   Click here

3. INSPECT LIGHTS, HORNS, WIPERS AND WASHERS

4. CLEAN OR REPLACE AIR CONDITIONING FILTER

   
   

   1. Remove the air conditioning filter Click here.

      Note

      Before removing the air conditioning filter, turn the power switch off and set the air conditioner to recirculation mode.

   2. Visually inspect the surface of the air conditioning filter.

   3. If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.

      Note

      Some filters are not able to be cleaned.

5. CORROSION INSPECTION

6. ROAD TEST

   
   

   1. Check the engine and chassis for abnormal noises.

   2. Check that the brakes work properly and do not drag.

   3. Set the parking brake shoes and drums.

7. INSPECT REFRIGERANT AMOUNT FOR AIR CONDITIONER

   
   

   1. Check the sight glass on the liquid tube.

      Type	See procedure
      HFC-134a(R134a)	Click here
      HFO-1234yf(R1234yf)	Click here

8. REPLACE AIR CONDITIONER COMPRESSOR

   
   

   1. Replace the air conditioner compressor Click here.

9. REPLACE HEATER WATER PUMP

   
   

   1. Replace the heater water pump Click here.