ENTRY AND START SYSTEM DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch ON (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus:


      1. Intelligent tester - Select: Body Electrical/ (desired system) / Data List.

    5. According to the display on intelligent tester, read the "Data List".

      Entry&Start
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Power Save Cnt 10 Min. Power save counter - 10 minutes / Min: 0 Max: 225 Within range from 0 to 225 -
      Power Save Cnt 9 Days Power save counter - 9 days / Min: 0 Max: 225 Within range from 0 to 225 -
      Power Save Cnt 14 Days Power save counter - 14 days / Min: 0 Max: 225 Within range from 0 to 225 -
      Power Save Cnt 30 Days Power save counter - 30 days / Min: 0 Max: 225 Within range from 0 to 225 -
      Unmatched Vehicle-ID No communication condition between vehicle and electrical key transmitter (vehicle-ID) / Yes or No

      Yes: Key ID code not matched to vehicle

      No: Key ID code matched to vehicle

      -
      No Response No communication condition between vehicle and electrical key transmitter (response) / Yes or No

      Yes: Key ID code not matched to vehicle

      No: Key ID code matched to vehicle

      -
      Unmatch Code or Form No communication condition between vehicle and electrical key transmitter (response code and format) / Yes or No

      Yes: Key ID code not matched to vehicle

      No: Key ID code matched to vehicle

      -
      Key Low Battery Key low battery / Yes or No

      Yes: Key battery voltage is low

      No: Key battery voltage is normal

      -
      ID Code Difference(Resp) No communication condition between vehicle and electrical key transmitter (ID code) / Yes or No

      Yes: Key ID code not matched to vehicle

      No: Key ID code matched to vehicle

      -
      C Code Difference No communication condition between vehicle and electrical key transmitter (challenge code) / Yes or No

      Yes: Key ID code not matched to vehicle

      No: Key ID code matched to vehicle

      -
      Door Unlock Mode Door unlock mode / All, Each, D_Door, Side Mode status is displayed -
      Auto Entry Cancel SW Entry door lock function cancel / ON or OFF Mode status is displayed -
      Trunk Open Mode Luggage compartment door open mode with vehicle locked / ON or OFF Customization status is displayed -
      Ignition Available Area Ignition available area / Front or All Customization status is displayed -
      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      IG SW Power switch ON (IG) / ON or OFF

      ON: Power switch is ON (IG)

      OFF: Power switch is OFF

      -
      ACC SW Power switch ON (ACC) / ON or OFF

      ON: Power switch is ON (ACC)

      OFF: Power switch is OFF

      -
      D Door Courtesy SW Driver side door courtesy light switch signal / ON or OFF

      ON: Driver side door is opened

      OFF: Driver side door is closed

      -
      P Door Courtesy SW Front passenger side door courtesy light switch signal / ON or OFF

      ON: Front passenger side door is opened

      OFF: Front passenger side door is closed

      -
      RL Door Courtesy SW Rear LH side door courtesy light switch signal / ON or OFF

      ON: Rear side door LH is opened

      OFF: Rear side door LH is closed

      -
      RR Door Courtesy SW Rear RH side door courtesy light switch signal / ON or OFF

      ON: Rear side door RH is opened

      OFF: Rear side door RH is closed

      -
      Driver Door
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Lock Position SW Driver side door lock position switch signal / ON or OFF

      ON: Driver side door is unlocked

      OFF: Driver side door is locked

      -
      Entry Sensor Driver side door touch sensor / ON or OFF

      ON: Driver side door sensor is touched

      OFF: Driver side door sensor is not touched

      -
      Outside Handle Trigger SW Driver side door outside handle lock switch / ON or OFF

      ON: Driver side door outside handle lock switch is pushed

      OFF: Driver side door outside handle lock switch is not pushed

      -
      Passenger Door
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Lock Position SW Front passenger side door lock position switch signal / ON or OFF

      ON: Front passenger side door is unlocked

      OFF: Front passenger side door is locked

      -
      Entry Sensor Front passenger side door touch sensor / ON or OFF

      ON: Front passenger side door sensor is touched

      OFF: Front passenger side door sensor is not touched

      -
      Outside Handle Trigger SW Front passenger side door outside handle lock switch / ON or OFF

      ON: Front passenger side door outside handle lock switch is pushed

      OFF: Front passenger side door outside handle lock switch is not pushed

      -
      Rear Left Door
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Lock Position SW Rear LH side door lock position switch signal / ON or OFF

      ON: Rear side door LH is unlocked

      OFF: Rear side door LH is locked

      -
      Entry Sensor Rear LH side door touch sensor / ON or OFF

      ON: Rear side door sensor LH is touched

      OFF: Rear side door sensor LH is not touched

      -
      Outside Handle Trigger SW Rear LH side door outside handle lock switch / ON or OFF

      ON: Rear side door outside handle lock switch LH is pushed

      OFF: Rear side door outside handle lock switch LH is not pushed

      -
      Rear Right Door
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Lock Position SW Rear RH side door lock position switch signal / ON or OFF

      ON: Rear side door RH is unlocked

      OFF: Rear side door RH is locked

      -
      Entry Sensor Rear RH side door touch sensor / ON or OFF

      ON: Rear side door sensor RH is touched

      OFF: Rear side door sensor RH is not touched

      -
      Outside Handle Trigger SW Rear RH side door outside handle lock switch / ON or OFF

      ON: Rear side door outside handle lock switch RH is pushed

      OFF: Rear side door outside handle lock switch RH is not pushed

      -
      Back Door
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Back Door Handle SW Luggage electrical key switch / ON or OFF

      ON: Luggage electrical key switch is pushed

      OFF: Luggage electrical key switch is not pushed

      -
      Courtesy SW Luggage compartment door courtesy light switch signal / ON or OFF

      ON: Luggage compartment door is opened

      OFF: Luggage compartment door is closed

      -
  2. PERFORM ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch ON (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus:


      1. Intelligent tester - Select: Body / Entry & Start / Active Test.

    5. According to the display on intelligent tester, perform the "Active Test".

      Entry&Start
      Tester Display Test Part Control Range Diagnostic Note
      Inside Luggage Tuner Power Supply On Door control receiver ON or OFF -
      Overhead Tuner Power Supply On Amplifier antenna ON or OFF -
      D-Seat Outside Transmitter Door electrical key oscillator ON or OFF -
      P-Seat Outside Transmitter Door electrical key oscillator ON or OFF -
      DR-Seat Outside Transmitter Door electrical key oscillator ON or OFF -
      PR-Seat Outside Transmitter Door electrical key oscillator ON or OFF -
      Fr-Seat Inside Transmitter Indoor electrical key oscillator (for Front Floor) ON or OFF -
      Rr-Seat Inside Transmitter Indoor electrical key oscillator (for Rear Floor) ON or OFF -
      Inside Trunk/Backdoor Transmitter Indoor electrical key oscillator (for Luggage Compartment) ON or OFF -
      Outside Trunk/Backdoor Transmitter Electrical key antenna ON or OFF -