WASHER MOTOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE FRONT WHEEL LH

  8. REMOVE FRONT FENDER MAIN SEAL LH

    Click here

  9. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH

    Click here

  10. REMOVE FRONT FENDER LINER LH

    Click here

  11. DRAIN WASHER FLUID


    1. A000X99

      Remove the washer hose from the windshield washer motor and pump, and drain the washer fluid.

  12. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    1. A000ZDS

      Disconnect the connector.

    2. Remove the windshield washer motor and pump assembly as shown in the illustration.

  13. REMOVE HEADLIGHT ASSEMBLY LH

    Click here

  14. REMOVE WASHER INLET SUB-ASSEMBLY


    1. A000X2M

      Remove the bolt and washer inlet.

  15. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


    1. Disconnect the 3 connectors and detach the 4 clamps.

      A000XM7E05

    2. Remove the 3 bolts. Then detach guide A and remove the windshield washer jar and pump.

  16. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY


    1. A000VTK

      Remove the headlight cleaner motor and pump assembly together with the hose.

  17. REMOVE HEADLIGHT CLEANER CONTROL RELAY


    1. A000VZL

      Detach the claw and remove the headlight cleaner control relay.

  18. REMOVE LEVEL WARNING SWITCH ASSEMBLY


    1. A000X4J

      Remove the level warning switch assembly.