WIPER AND WASHER SYSTEM Washer Motor Circuit

DESCRIPTION

The front controller receives washer switch information from the front wiper switch, and operates the wash relay.

WIRING DIAGRAM

A000VLME02

PROCEDURE


  1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FRONT WASHER MOTOR)


    1. Select the Active Test, use the intelligent tester to generate a control command, and then check the front washer motor.

      Note

      When a Body No. 5 (front controller) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.

      Body No. 5:
      Item Test Details Control Range Diagnostic Note
      Washer Motor Operation Washer motor OFF / ON -
      OK
      Washer motor operates.

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. INSPECT FRONT WASHER MOTOR


    1. A000YJ5E01
      *1 Component without harness connected: (Front Washer Motor)

      Remove the front washer motor Click here.

    2. Apply battery voltage to the windshield washer motor and check the operation of the windshield washer motor.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 1

      Battery negative (-) → Terminal 2

      		 Front washer motor operation is normal

    NG

    REPLACE FRONT WASHER MOTOR Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (FRONT WASHER MOTOR - FRONT CONTROLLER AND BODY GROUND)


    1. A000Y4CE03
      *1 Front view of wire harness connector:(to Front Controller)
      *2 Front view of wire harness connector: (to Front Washer Motor)

      Disconnect the A51 front controller connector.

    2. Disconnect the A1 washer motor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      A1-1 - A51-17 (W1) Always Below 1 Ω
      A1-2 - Body ground Always Below 1 Ω
      A1-1 - Body ground Always 10 kΩ or higher

    OK

    REPLACE FRONT CONTROLLER

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR