WIPER AND WASHER SYSTEM Headlight Cleaner Motor and Relay Circuit

DESCRIPTION

This circuit provides power to the headlight cleaner control relay.

The headlight cleaner control relay sends the signal from the switch, etc. to the headlight cleaner motor to operate the headlight cleaner system.

WIRING DIAGRAM

A000WVXE10

CAUTION / NOTICE / HINT

Note

Inspect the fuses and relays for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - BATTERY AND BODY GROUND)


    1. A000VFVE03
      *1 Front view of wire harness connector: (to Headlight Cleaner Control Relay)

      Disconnect the A6 headlight cleaner control relay connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Switch Condition Specified Condition
      A6-3 (IG) - Body ground Power switch ON (IG) 11 to 14 V
      A6-3 (IG) - Body ground Power switch OFF Below 1 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      A6-4 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT HEADLIGHT CLEANER MOTOR


    1. A000TKS

      Remove the headlight cleaner motor Click here.

    2. Apply battery voltage to the headlight cleaner motor and check the operation of the headlight cleaner motor.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 2

      Battery negative (-) → Terminal 1

      		 Headlight cleaner motor operation is normal

    NG

    REPLACE HEADLIGHT CLEANER MOTOR Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER MOTOR - HEADLIGHT CLEANER CONTROL RELAY AND BATTERY)


    1. A000Z0GE02
      *1 Front view of wire harness connector: (to Headlight Cleaner Motor)
      *2 Front view of wire harness connector: (to Headlight Cleaner Control Relay)

      Disconnect the A92 headlight cleaner motor connector.

    2. Disconnect the A6 headlight cleaner control relay connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      A92-2 - Body ground Always 11 to 14 V

    4. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      A92-1 - A6-6 (PB) Always Below 1 Ω
      A92-1 - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR