TURN SIGNAL FLASHER ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  2. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  3. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  4. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  5. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  8. REMOVE TURN SIGNAL FLASHER ASSEMBLY

    A000TYE

    1. Detach the clamp.

    2. Disconnect the connector to remove the turn signal flasher assembly.