HAZARD WARNING SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL NO. 2 RADIO BRACKET


    1. Install the No. 2 radio bracket with the 3 bolts.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  2. INSTALL NO. 1 RADIO BRACKET


    1. Install the No. 1 radio bracket with the 3 bolts.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  3. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY


    1. Connect the connectors.

    2. Attach the 6 clips to install the multi-media module receiver assembly (hazard warning switch).

    3. Install the 2 bolts.

  4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  5. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  7. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

    Click here

  8. INSTALL NO. 3 BOX PANEL

    Click here

  9. INSTALL UPPER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  11. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  12. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click here