HAZARD WARNING SWITCH INSPECTION

PROCEDURE


  1. INSPECT MULTI-MEDIA MODULE RECEIVER ASSEMBLY (HAZARD WARNING SWITCH)

    A000VUPE01
    Text in Illustration
    *a

    Component without harness connected

    {Multi-media Module Receiver Assembly (Hazard Warning Switch)}

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      9 (HAZ) - Body ground Hazard warning signal switch off 10 kΩ or higher
      Hazard warning signal switch on Below 1 Ω

      • If the result is not as specified, replace the multi-media module receiver assembly (hazard warning switch).

        Text in Illustration
        *a

        Component without harness connected

        {Multi-media Module Receiver Assembly (Hazard Warning Switch)}