FOG LIGHT ASSEMBLY(for Sport Package) REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FOG LIGHT COVER


    1. Install the fog light cover to the fog light unit LH.

  2. INSTALL FOG LIGHT CORD

    A000ZX5E01
    Text in Illustration
    *1 Grommet

    1. Connect the grommet and attach the clamp to install the fog light cord.

      Note

      Make sure that the grommet is securely installed.

    2. A000VT2E01
      Text in Illustration
      *1 LED Unit

      Connect the connector and attach the clamp.

      Note


      • Wear rubber gloves when installing the fog light cord in order to protect your hands, prevent fingerprints and to keep the lens free from foreign matter. Do not use cotton gloves.

      • Do not touch the aluminum surfaces of the LED unit, etc. with bare hands.

      • If there are fingerprints on the aluminum surfaces of the LED unit, etc., wipe them off with a soft cloth.

      • Do not allow dirt or foreign matter on the aluminum surfaces of the LED unit, etc.

  3. INSTALL FOG LIGHT LENS GASKET

    A000XD0

    1. Completely remove the old fog light lens gasket.

    2. Partially remove the peeling paper, and cut off a piece of it.

    3. Fold the peeling paper over the tip of a screwdriver and fix it in place with tape.

      Note

      Use the peeling paper that is supplied with the fog light lens gasket.

    4. Using scissors, cut the end of the fog light lens gasket at a diagonal (45°).

    5. A000XCCE01

      Set the fog light lens gasket into the groove so that the ends of the fog light lens gasket are aligned with the bottom of the fog light unit LH as shown in the illustration.

    6. Using the screwdriver, completely press the fog light lens gasket into the fog light unit LH to install the fog light lens gasket.

    7. After pressing the fog light lens gasket completely, cut the fog light lens gasket ends at a diagonal (45°) so that the ends overlap for 10 mm (0.394 in.) or more.

      Text in Illustration
      *1 Peeling Paper
      *2 Tape
      *a 10 mm

  4. INSTALL FOG LIGHT LENS LH


    1. Attach the 2 claws to install the fog light lens LH.

      Note


      • Wear rubber gloves when installing the fog light lens LH in order to protect your hands, prevent fingerprints and to keep the lens free from foreign matter. Do not use cotton gloves.

      • Do not touch the rear side of the fog light lens LH or the aluminum surfaces of the LED unit with bare hands.

      • If there are fingerprints on the aluminum surfaces of the LED unit, etc., wipe them off with a soft cloth.

      • If there are fingerprints on the back of the lens, replace the fog light lens LH.

      • Do not allow dirt or foreign matter on the rear side of the fog light lens LH or aluminum surfaces of the LED unit.

    2. Install the 4 screws.