FOG LIGHT ASSEMBLY(for Sport Package) DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FOG LIGHT LENS LH

    A000Y84

    1. Remove the 4 screws.

    2. A000URI

      Using a dryer, heat the backside of the fog light unit LH.

      Note

      If the fog light is heated unevenly, it will deform or melt.

    3. A000WY1

      Detach the 2 claws and remove the fog light lens LH from the fog light unit LH.

      Note


      • Wear rubber gloves when removing the fog light lens LH in order to protect your hands, prevent fingerprints and to keep the lens free from foreign matter. Do not use cotton gloves.

      • Do not touch the rear side of the fog light lens LH or the aluminum surfaces of the LED unit with bare hands.

      • If there are fingerprints on the aluminum surfaces of the LED unit, etc., wipe them off with a soft cloth.

      • If there are fingerprints on the back of the lens, replace the fog light lens LH.

      • Do not allow dirt or foreign matter on the rear side of the fog light lens LH or aluminum surfaces of the LED unit.

      Tech Tips

      If the lens cannot be removed even after heating, using a screwdriver with its tip wrapped in protective tape, lift the lens. Be careful not to damage the fog light unit LH and fog light lens LH.

  2. REMOVE FOG LIGHT LENS GASKET


    1. Remove the fog light lens gasket from the fog light unit LH.

  3. REMOVE LIGHT CONTROL ECU

    A000TAI

    1. Remove the 2 screws.

    2. Disconnect the connector and remove the light control ECU.

  4. REMOVE FOG LIGHT CORD

    A000VT2E01
    Text in Illustration
    *1 LED Unit

    1. Disconnect the connector and detach the clamp.

      Note


      • Wear rubber gloves when removing the fog light cord in order to protect your hands, prevent fingerprints and to keep the lens free from foreign matter. Do not use cotton gloves.

      • Do not touch the aluminum surfaces of the LED unit, etc. with bare hands.

      • If there are fingerprints on the aluminum surfaces of the LED unit, etc., wipe them off with a soft cloth.

      • Do not allow dirt or foreign matter on the aluminum surfaces of the LED unit, etc.

    2. A000ZX5E01
      Text in Illustration
      *1 Grommet

      Detach the clamp and disconnect the grommet remove the fog light cord.

  5. REMOVE FOG LIGHT COVER

    A000Y8Z

    1. Remove the fog light cover from the fog light unit LH.