INTRUSION SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE MAP LIGHT ASSEMBLY


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  8. REMOVE THEFT WARNING RADAR SENSOR


    1. A000UTZ

      Remove the 2 screws.

    2. A000WOP

      Disconnect the connector and remove the 4 screws.

    3. Detach the 4 clamps and remove the theft warning radar sensor.