FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE SEAT BELT ANCHOR COVER CAP LH


    1. Operate the power seat switch assembly (slide switch) to move the seat to the foremost position.

    2. A000W7L

      Detach the 4 claws and guide to remove the seat belt anchor cover cap LH by pulling it in the direction indicated by the arrow in the illustration.

  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH


    1. A000VLA

      Remove the bolt and disconnect the anchor part of the front seat outer belt assembly LH.

  9. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  10. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  11. REMOVE REAR DOOR SCUFF PLATE LH


    1. for Standard Body:

      Click here

    2. for Long Body:

      Click here

  12. REMOVE CENTER LOWER PILLAR GARNISH LH

    Click here

  13. REMOVE CENTER UPPER PILLAR GARNISH LH

    Click here

  14. REMOVE FRONT SEAT SHOULDER BELT GUIDE

    A000TJN

    1. Remove the 2 screws and front seat shoulder belt guide.

  15. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

    A000Y0T

    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A000ZUSE03

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration labeled A.

      Tech Tips

      Tape the screwdriver tip before use.

    3. w/ Tension Reducer System:

      Disconnect the tension reducer connector labeled B.

    4. w/ Pre-crash Safety System:

      Disconnect the pre-crash safety connector labeled C.

    5. A000X4M

      Remove the 2 bolts and front seat outer belt assembly LH.

  16. REMOVE HEIGHT ADJUSTABLE ANCHOR MOTOR LH


    1. A000Y6P

      Disconnect the connector.

    2. Detach the 2 claws and pull the height adjustable anchor motor LH downward to remove it from the front shoulder belt anchor adjuster assembly as shown in the illustration.

  17. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A000VZZ

      Remove the 2 bolts and front shoulder belt anchor adjuster assembly.