LIGHT CONTROL RHEOSTAT REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. DISABLE AUTOAWAY/RETURN FUNCTION


    1. Disable the autoaway/return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully retract and tilt up the steering column assembly.

    3. Turn the power switch off.

  2. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  3. REMOVE INSTRUMENT PANEL ORNAMENT

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  6. REMOVE LIGHT CONTROL RHEOSTAT


    1. A000TZS

      Detach the 2 claws and remove the light control rheostat from the No. 2 instrument cluster finish panel sub-assembly.