АДСОРБЕР СНЯТИЕ

PROCEDURE


  1. REMOVE FLOOR NO. 1 UNDER COVER


    1. Remove the 2 hole plugs.

    2. A001EO8

      Remove the 5 nuts, 5 clips and under cover.

  2. REMOVE CANISTER


    1. A001FHOE02
      *1 Up
      *2 Retainer
      *3 Pinch

      Disconnect the fuel tube.


      1. Pinch the retainer and then raise it.

        Note

        A001DLEE05

        • Do not use any tools in this procedure.

        • Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.

        • Do not allow any scratches or foreign objects on the parts when disconnecting the tube.

        • Do not forcibly bend, twist or turn the nylon tube.

        • Protect the disconnected part by covering it with a plastic bag after disconnecting the tube.

        • If the tube connector and pipe are stuck, push and pull to release them.

    2. Disconnect the 2 canister hoses.

    3. A001EL8E01
      *1 Nut

      Remove the 4 bolts, 2 plastic nuts and canister.

    4. Disconnect the purge line hose from the canister.

  3. REMOVE CANISTER SUPPORT BRACKET

    A001AVU

    1. Remove the 4 nuts and canister support bracket.