БЛОК ДВИГАТЕЛЯ ЗАМЕНА

PROCEDURE

1. REPLACE TIMING CHAIN COVER STRAIGHT PIN

   
   
   1. 

      *1	5.5 to 6.5 mm

      Remove the straight pin.

   2. Using a plastic-faced hammer, tap in new straight pins to the timing chain cover.

      Standard protrusion
      5.5 to 6.5 mm (0.217 to 0.256 in.)

2. REPLACE TIMING CHAIN COVER RING PIN

   
   
   1. 

      *1	3.6 to 4.6 mm
      *2	7.5 to 8.5 mm

      Remove the ring pin.

   2. Using a plastic-faced hammer, tap in new ring pins to the timing chain cover.

      Standard protrusion
      Item Specified Condition Ring pin A 7.5 to 8.5 mm (0.295 to 0.335 in.) Ring pin B 3.6 to 4.6 mm (0.142 to 0.181 in.)

3. REPLACE OIL PAN STUD BOLT

   
   

   1. Remove the 2 stud bolts.

   2. 

      *1	9 mm (0.354 in.)
      *2	19 mm (0.748 in.)

      Using an E6 "TORX" socket wrench, install the 2 stud bolts as shown in the illustration.

      Torque:

      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

4. REPLACE ENGINE REAR OIL SEAL

   
   

   1. 

      *1	Wooden Block

      Place the oil seal retainer on wooden blocks.

   2. Using a screwdriver and hammer, tap out the oil seal.

   3. 

      Using SST, tap in a new oil seal until its surface is flush with the oil seal retainer edge.

      SST

      09223-15030

      09950-70010   ( 09951-07100 )

      Note

      
      

      • Keep the lip free from foreign matter.

      • Do not tap on the oil seal at an angle.