ПРОКЛАДКА ГОЛОВКИ БЛОКА ЦИЛИНДРОВ (для ряда 2) УСТАНОВКА

PROCEDURE


  1. INSPECT CYLINDER HEAD SET BOLT

    Click here

  2. INSPECT CYLINDER HEAD SUB-ASSEMBLY

    Click here

  3. INSTALL CYLINDER HEAD SUB-ASSEMBLY (for Bank 2)


    1. Check the piston protrusions for each cylinder.


      1. Clean the cylinder block with solvent.

      2. Set the piston of the cylinder to be measured to slightly ATDC.

    2. A001D98E01
      *1 Front
      *2 Lot No.

      Place the cylinder head gasket on the cylinder block surface with the front face of the Lot No. stamp upward.

      Note


      • Be careful of the installation direction.

      • Gently place the cylinder head in order not to damage the gasket with the bottom part of the head.

    3. Place the cylinder head on the cylinder block.

      Note

      Ensure that no oil is on the mounting surface of the cylinder head.

      Tech Tips

      The cylinder head bolts are tightened in 3 progressive steps.

    4. Apply a light coat of engine oil to the threads and under the heads of the cylinder head bolts.

    5. A001EOZE06

      Step 1:


      1. Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 10 cylinder head bolts with the plate washers in several steps, in the sequence shown in the illustration.

        Torque:
        36 N*m  { 367 kgf*cm, 27 ft.*lbf }
    6. A001DOCE01
      *1 Front
      *2 Painted Mark

      Step 2:


      1. Mark the cylinder head bolt head with paint as shown in the illustration.

      2. Tighten the cylinder head bolts another 90° in the sequence shown in step 1.

    7. Step 3:


      1. Tighten the cylinder head bolts by an additional 90° in the sequence shown in step 1.

      2. Check that the painting marks are now facing rearward.

    8. A001EKEE06

      Uniformly install the 2 cylinder head bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

  4. INSTALL VALVE STEM CAP


    1. Apply a light coat of engine oil to the valve stem caps.

    2. Install the 16 valve stem caps to the cylinder head.

  5. INSTALL VALVE LASH ADJUSTER ASSEMBLY


    1. Be sure to inspect the valve lash adjuster before installing it Click here.

    2. Install the 16 valve lash adjusters to the cylinder head.

      Note

      Install the lash adjuster at the same place it was removed from.

  6. INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY


    1. Apply engine oil to the lash adjuster tips and valve stem cap ends.

    2. A0019WFE02
      Text in Illustration
      *1 No. 1 Valve Rocker Arm Sub-assembly
      *2 Valve Stem Cap
      *3 Valve Lash Adjuster Assembly

      Make sure that the valve rocker arms are installed as shown in the illustration.

  7. INSTALL CAMSHAFT (for Bank 2)

    Click here