ДАТЧИК ДЕТОНАЦИИ УСТАНОВКА

PROCEDURE


  1. INSTALL KNOCK SENSOR

    A001EOQE12

    1. Install the 4 knock sensors with the 4 bolts so that the sensors are angled as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note

      The acceptable installation angle of the knock control sensors is between 10° upwards and downwards from the horizontal position.

    2. Connect the 4 knock sensor connectors.

  2. INSTALL SEPARATOR CASE

    A001BSE

    1. Install the separator case with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. REMOVE NO. 3 ENGINE COVER

    A001BDU

  4. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY LH

    A0018V0

  5. INSTALL INTAKE MANIFOLD

    Click here