ПЕДАЛЬ АКСЕЛЕРАТОРА ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE


  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY


    1. Connect the Techstream to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the tester on.

    4. Enter the following menus: Powertrain / Engine / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

    5. Read the value displayed on the tester.

      Accel Sensor Out No. 1 Standard Voltage
      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V
      Accel Sensor Out No. 2 Standard Voltage
      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor, wire harness or ECM.