REAR DOOR WINDOW FRAME MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • When removing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)

Note

Do not heat the vehicle body or window frame moulding excessively.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  4. REMOVE ASSIST GRIP COVER LH

    Click here

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  8. REMOVE REAR DOOR GLASS RUN LH

    Click here

  9. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  10. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  12. REMOVE REAR DOOR BELT MOULDING LH

    Click here

  13. REMOVE REAR DOOR WEATHERSTRIP LH

    B001F7U

    1. Detach the clip and remove the upper part of the rear door weatherstrip so that the moulding can be removed.

  14. REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH


    1. B001CNU

      Remove the door window frame moulding clip.

    2. B001GMJE03

      Put protective tape around the rear door front window frame moulding.

    3. Using a moulding remover, detach the clip and remove the double-sided tape to remove the rear door front window frame moulding.

      Text in Illustration
      *1 Protective Tape
      *2 Double-sided Tape
      *3 Moulding Remover