REAR DOOR WINDOW FRAME MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)

Note

Do not heat the vehicle body or window frame moulding excessively.

PROCEDURE


  1. INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING LH


    1. Clean the vehicle body surface.


      1. Using a heat light, heat the vehicle body surface.

      2. Remove the double-sided tape from the vehicle body surface.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Install a new rear door front window frame moulding.


      1. Using a heat light, heat a new rear door front window frame moulding and the vehicle body surface.

      2. Remove the peeling paper from the face of the rear door front window frame moulding.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      3. Attach the clip and double-sided tape to install the rear door front window frame moulding.

        Tech Tips

        Press the rear door front window frame moulding firmly to install it.

    3. Install a new door window frame moulding clip.

  2. INSTALL REAR DOOR WEATHERSTRIP LH


    1. Attach the clip to install the upper part of the rear door weatherstrip.

  3. INSTALL REAR DOOR BELT MOULDING LH

    Click here

  4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  5. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  7. INSTALL REAR DOOR GLASS RUN LH

    Click here

  8. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. INSTALL ASSIST GRIP COVER LH

    Click here

  12. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.