REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  4. REMOVE ASSIST GRIP COVER LH

    Click here

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  8. REMOVE REAR DOOR GLASS RUN LH

    Click here

  9. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  10. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  12. REMOVE REAR DOOR BELT MOULDING LH

    B001DAVE03
    Text in Illustration
    *1 Protective Tape

    1. Detach the 7 claws and remove the rear door belt moulding.