FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  5. REMOVE ASSIST GRIP COVER LH

    Click here

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  8. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  12. REMOVE FRONT DOOR BELT MOULDING LH

    B001COIE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the belt moulding.

    2. Detach the 6 claws and remove the front door belt moulding.