AUTOMATIC HIGH BEAM MAIN SWITCH INSPECTION

PROCEDURE


  1. INSPECT AUTO HIGH BEAM SWITCH


    1. Inspect the auto high beam switch.


      1. B001DPWC01
        *a

        Component without harness connected

        (Auto High Beam Switch)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        5(+B) - 2(E) Auto high beam switch off 10 kΩ or higher
        Auto high beam switch on Below 1 Ω
        If the result is not as specified, replace the auto high beam switch.

    2. Inspect the Illumination.


      1. B001DPWC02
        *a

        Component without harness connected

        (Auto High Beam Switch)

        Apply battery voltage to the connector and check the illumination condition.

        OK
        Battery Connection Specified Condition

        Positive (+) → 6(ILL+)

        Negative (-) → 1(ILL-)

        		 Illuminates
        If the result is not as specified, replace the auto high beam switch.