TURN SIGNAL FLASHER ASSEMBLY ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK TURN SIGNAL FLASHER ASSEMBLY


    1. A01XGZEE03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Turn Signal Flasher Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      5 (E) - Body ground Always Below 1 Ω

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      2 (LR) - 7 (E) Hazard warning switch off Below 1 V
      Hazard warning switch on

      Alternating between 11 to 14 V and below 1 V

      (60 to 120 times per minute)
      3 (LL) - 7 (E) Hazard warning switch off Below 1 V
      Hazard warning switch on

      Alternating between 11 to 14 V and below 1 V

      (60 to 120 times per minute)
      4 (B) - 7 (E) Always 11 to 14 V
      5 (EL) - 7 (E)

      Ignition switch ON

      Headlight dimmer switch (turn left) off

      		 9 V or higher

      Ignition switch ON

      Headlight dimmer switch (turn left) on

      		 Below 1 V
      6 (ER) - 7 (E)

      Ignition switch ON

      Headlight dimmer switch (turn right) off

      		 9 V or higher

      Ignition switch ON

      Headlight dimmer switch (turn right) on

      		 Below 1 V
      8 (HAZ) - 7 (E) Hazard warning switch off 9 V or higher
      Hazard warning switch on Below 1 V

      If the result is not as specified, there may be a malfunction in the turn signal flasher.