LIGHTING SYSTEM(for LED Headlight) PRECAUTION


  1. IGNITION SWITCH EXPRESSIONS


    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression Ignition Switch (Position) Engine Switch (Condition)
      Ignition Switch off LOCK Off (Lock)
      Ignition Switch ACC ACC On (ACC)
      Ignition Switch ON ON On (IG)
      Engine Start START On (Start)

  2. PRECAUTION FOR EACH BULB REPLACEMENT


    1. Always prepare a new bulb for immediate replacement. While replacing a bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.

    2. Always replace a bulb with another bulb of the same wattage.

    3. If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.

    4. Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through gaps around the socket if the socket is not installed securely.

  3. PRECAUTION FOR HEADLIGHT BEAM AXIS ADJUSTMENT


    1. The headlight outer lens is made of synthetic resin and may melt or be damaged due to excessive heat. Therefore, do not keep the headlight covered for 3 minutes or more when the headlight is on.

  4. HANDLING PRECAUTIONS FOR FORWARD RECOGNITION CAMERA (w/ Automatic High Beam System)


    1. The automatic high beam system uses the forward recognition camera. For precautions related to the forward recognition camera, refer to Precaution for Forward Recognition Camera System.

      Click here

  5. PRECAUTION WHEN REPLACING NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH


    1. If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH

      Click here