REAR WIPER MOTOR INSTALLATION

PROCEDURE

1. INSTALL REAR WIPER MOTOR ASSEMBLY

   
   

   1. Attach the 2 guides and temporarily install the rear wiper motor assembly with the 3 bolts.

   2. Tighten the 3 bolts.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   3. Connect the connector.

2. INSTALL REAR WIPER ARM

   
   
   1. 

      Text in Illustration

      *1	Wiper Arm Pivot Serrations

      Clean the wiper arm serrations.

   2. 

      Text in Illustration

      *1	Wiper Pivot Serrations
      *2	Wire Brush

      Clean the wiper pivot serrations with a wire brush.

   3. Operate the rear wiper and stop the rear wiper motor at the automatic stop position.

      Tech Tips

      The wiper motor does not operate if the back door and back door glass are not closed.

   4. 

      Text in Illustration

      *A	w/o Back Door Tire Carrier
      *B	w/ Back Door Tire Carrier
      *1	Ceramic Dot
      *a	Upper Limit
      *b	Lower Limit

      Align the blade tip with the mark on the glass as shown in the illustration.

      Standard
      Area Standard Condition a 10.0 mm (0.394 in.) b 10.0 mm (0.394 in.)

   5. Install the rear wiper arm and blade assembly with the nut.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the wiper arm by hand while tightening the nut.

3. INSTALL REAR WASHER NOZZLE SUB-ASSEMBLY

   Click here

4. INSTALL REAR SPOILER SUB-ASSEMBLY

   
   

   1. w/o Back Door Tire Carrier:

      Install the rear spoiler sub-assembly Click here.

   2. w/ Back Door Tire Carrier:

      Install the rear spoiler sub-assembly Click here.

5. INSTALL REAR SPOILER COVER RH

   Click here

6. INSTALL REAR NO. 1 SPOILER COVER (w/o Back Door Tire Carrier)

   Click here

7. INSTALL BACK DOOR SIDE GARNISH LH (w/ Back Door Tire Carrier)

   Click here

8. INSTALL BACK DOOR SIDE GARNISH RH (w/ Back Door Tire Carrier)

   Click here

9. INSTALL BACK DOOR CENTER GARNISH (w/ Back Door Tire Carrier)

   Click here