WIPER AND WASHER SYSTEM Washer Fluid Level Warning Switch Circuit

DESCRIPTION

When the volume of washer fluid decreases to below a certain level (when the level warning switch assembly is turned on), the multi-information display warns the driver by displaying a message*1 or the combination meter assembly warns the driver by displaying a washer fluid warning light*2.


WIRING DIAGRAM

B001FN6E05

CAUTION / NOTICE / HINT

Note

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

PROCEDURE


  1. READ VALUE USING GTS (WASHER SWITCH)


    1. Use the Data List to check if the level warning switch assembly is functioning properly Click here.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Washer Switch Level warning switch / ON or OFF

      ON: Fluid volume is less than 550 to 750 cc (33.5 to 45.7 cu.in.)

      OFF: Fluid volume is more than 550 to 750 cc (33.5 to 45.7 cu.in.)

      		 -
      OK
      On GTS screen, item changes between ON and OFF according to above chart.

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. INSPECT LEVEL WARNING SWITCH ASSEMBLY


    1. Remove the level warning switch assembly Click here.

    2. Inspect the level warning switch assembly Click here


    NG

    REPLACE LEVEL WARNING SWITCH ASSEMBLY Click here

    OK

  3. INSPECT WASHER WIRING ASSEMBLY


    1. B001H3RE03

      Disconnect the A23 and B washer wiring assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A23-3 (S) - B-1 Always Below 1 Ω
      A23-6 (E) - B-2 Always Below 1 Ω
      A23-3 (S) or B-1 - Body ground Always 10 kΩ or higher
      A23-6 (E) or B-2 - Body ground Always 10 kΩ or higher

    NG

    REPLACE WASHER WIRING ASSEMBLY

    OK

  4. CHECK HARNESS AND CONNECTOR (WASHER WIRING ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)


    1. Disconnect the A23 washer wiring assembly connector.

    2. Disconnect the G304 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A23-3 (S) - G304-30 (WLVL) Always Below 1 Ω
      A23-6 (E) - Body ground Always Below 1 Ω
      A23-3 (S) or G304-30 (WLVL) - Body ground Always 10 kΩ or higher

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR