WASHER NOZZLE(for Front Side) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSPECT WASHER NOZZLE SUB-ASSEMBLY


    1. With the engine running, check the position that the washer fluid hits the windshield.

      Standard
      Washer fluid hits the windshield in the areas shown in the illustration.
      B001CVCC01
      *1 Ceramic Line - -
      *a Upper Limit *b Standard
      *c Lower Limit - -
      B001CE2 Washer Fluid Spray Area - -
      Standard Clearance
      Area Specified Condition Area Specified Condition
      A 72 mm (2.835 in.) B 305 mm (12.008 in.)
      C 127 mm (5.000 in.) D 11 mm (0.433 in.)

      Tech Tips

      If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.