SLIDING ROOF HOUSING REASSEMBLY

PROCEDURE


  1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A01XM2Z

      Hold down the window deflector.

      Note

      Make sure that the spring indicated by the arrow in the illustration is securely installed.

    2. A01XL75E01
      Text in Illustration
      *1 Protective Tape
      B001CHY Slide

      Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01XEV6E01
      Text in Illustration
      *a Forward

      Slide the rear roof drip channel forward and attach the 2 claws to install it.

    4. Install the 2 stoppers with the 2 screws.

      A01XHLY

  2. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    A01XDUWE01
    Text in Illustration
    *1 Matchmark A
    *2 Matchmark B
    *3 Protective Tape

    1. Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

  3. INSTALL SLIDING ROOF SUNSHADE STOPPER LH


    1. A01XDNW

      Install the stopper.

  4. INSTALL SLIDING ROOF SUNSHADE STOPPER RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. Insert the sunshade trim into the sliding roof housing.

      A01XK9LE01
      Text in Illustration
      *a Forward - -

    2. Attach the 4 claws to install the sliding roof piece LH and RH.

    3. Install the 2 screws.

  6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. Install the drive gear with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    2. A01XFI1

      Attach the bracket claw to install the bracket.