SLIDING ROOF HOUSING DISASSEMBLY

PROCEDURE


  1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A01XFI1

      Detach the bracket claw and remove the bracket.

    2. Remove the 2 bolts and drive gear.

  2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

    A01XCBYE01
    Text in Illustration
    *a Rearward - -

    1. Remove the 2 screws.

    2. Detach the 4 claws and remove the sliding roof piece LH and RH.

    3. Slide and remove the trim.

  3. REMOVE SLIDING ROOF SUNSHADE STOPPER LH


    1. A01XDNW

      Remove the stopper.

  4. REMOVE SLIDING ROOF SUNSHADE STOPPER RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


    1. Remove the 2 screws and 2 stoppers.

      A01XHLY
    2. A01XF5ZE01
      Text in Illustration
      *1 Protective Tape
      *a Rearward

      Using a screwdriver, detach the 2 claws and slide the rear roof drip channel rearward to remove it.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01XE1S

      Hold down the window deflector.

    4. A01XF1IE02
      Text in Illustration
      *1 Matchmark A
      *2 Matchmark B

      Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.

    5. A01XI67E01
      Text in Illustration
      *1 Protective Tape
      B001CHY Slide

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      Tech Tips

      Tape the screwdriver tip before use.