WINDSHIELD DEICER SWITCH INSPECTION

PROCEDURE


  1. INSPECT FRONT WIPER DEICER SWITCH


    1. B001CEFC04
      *a

      Component without harness connected

      (Front Wiper Deicer Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      2 (E) - 5 (IG) Front wiper deicer switch on Below 1 Ω
      Front wiper deicer switch off 10 kΩ or higher

      If the result is not as specified, replace the front wiper deicer switch.

    2. Apply battery voltage to the connector and check the LED illumination.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 5 (IG)

      Battery negative (-) → 4 (D)

      		 Indicator LED illuminates

      Battery positive (+) → 6 (ILL+)

      Battery negative (-) → 1 (ILL-)

      		 Illumination LED illuminates

      If the result is not as specified, replace the front wiper deicer switch.