POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. Apply MP grease to the sliding and rotating areas of the regulator motor.

    2. Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  4. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  5. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR GLASS RUN LH

    Click here

  7. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  8. INSTALL REAR SPEAKER SET

    Click here

  9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. INSTALL ASSIST GRIP COVER LH

    Click here

  12. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  14. INITIALIZE POWER WINDOW CONTROL SYSTEM


    1. Initialize the power window control system Click here.