POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  3. REMOVE ASSIST GRIP COVER LH

    Click here

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  6. REMOVE REAR SPEAKER SET

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  8. REMOVE REAR DOOR GLASS RUN LH

    Click here

  9. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  10. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  12. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY LH

    Click here

  13. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    B001DO3

    1. Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor.